Lap-Shoulder Belt Installation - Britax MARATHON 65 Manual

Rear-Facing Installation

Lap-Shoulder Belt Installation

Before You Begin:
• Check that your vehicle belt is compatible for use with child
seats. See pages 8 – 13 for more information.
* If your vehicle seat belt system includes a locking feature,
use of the lock-offs is not required as long as the vehicle seat
belt system is locked. Check your vehicle owner's manual
to determine how to lock your vehicle seat belt system when
installing a child restraint.
• This child seat must be reclined to position 3 when
installed rear-facing.
* When properly installed in the rear-facing
position, the back angle of the child seat
should be at least 30˚ for children and up
to 45˚ from vertical for infants unable to
maintain head and neck control (not to
exceed 45˚) when the car is parked on a
level surface. Use the blue line as a guide to
achieve the proper recline angle for rear-
facing installations. The blue line will be parallel to the ground
when the child seat angle is at the center of the angle range (30
– 45˚). If necessary, the proper recline angle can be achieved
by placing a rolled towel or pool noodle in the vehicle seat bight.
• Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner's manual for
tether anchor locations. See page 25 for possible rear-facing
tether configurations.
32
Install with lap-shoulder belt as shown above.
IMPORTANT: The harness buckle strap should lie toward
the back of the child seat during installation.
Rear-Facing Installation
33