Table of Contents
Advertisement
To calculate 195 blinks in 5 minutes as
_blinks/_min:
195_blinks/(5_min)
Notes:
•
User-defined units are displayed in lowercase characters, regardless of the case you
use to define them.
•
User-defined units such as _dm are stored as variables. You can delete them the
same as you would any variable.
List of Pre-Defined Constants and Units
List of Pre-Defined Constants and Units
List of Pre-Defined Constants and Units
List of Pre-Defined Constants and Units
This section lists the pre-defined constants and units by category. You can select any of
these from the UNITS dialog box. If you use 3 to set default units, note that
categories with only one defined unit are not listed.
Defaults for SI and ENG/US
Defaults for SI and ENG/US
Defaults for SI and ENG/US
Defaults for SI and ENG/US
The SI and ENG/US systems of measurement use built-in default units. In this section,
the built-in defaults are indicated by (SI) and (ENG/US). In some categories, both
systems use the same default.
Some categories do not have default units.
Constants and Measurement Units
Assuming unit
default for Time is
set to _s.
290
Advertisement
Table of Contents
