Texas Instruments Voyage 200 User Manual page 917

670 Memory
673
680 Missing (
690 Missing )
700 Missing "
710 Missing ]
720 Missing }
730 Missing start or end of block syntax
740 Missing Then in the If..EndIf block
750 Name is not a function or program
765 No functions selected
780 No solution found
790 Non-algebraic variable in expression
800 Non-real result
810 Not enough memory to save current variable. Please delete unneeded
variables on the Var-Link screen and re-open editor as current OR re-
open editor and use F1 8 to clear editor.
830 Overflow
840 Plot setup
850 Program not found
855 Rand type functions not allowed in 3D graphing
860 Recursion is limited to 255 calls deep
870 Reserved name or system variable
875 ROM-resident routine not available
880 Sequence setup
885 Signature error
890 Singular matrix
Appendix B: Technical Reference
The calculation required more memory than was available at that
time. If you get this error when you run a large program, you may
need to break the program into separate, smaller programs or
functions (where one program or function calls another).
Using the interactive math features (F5:Math) in the Graph
application can give this error. For example, if you attempt to find an
inflection point of the parabola y1(x)=x
error will be displayed.
If a is the name of a PIC, GDB, MAC, FIG, etc., a+1 is invalid. Use a
different variable name in the expression or delete the variable.
For example, if the unit is in the REAL setting of the Complex Format
mode, ln(-2) is invalid.
This error message is caused by very low memory conditions inside
the Data/Matrix Editor.
A program reference inside another program could not be found in
the provided path during execution.
2
, which does not exist, this
911