Computer Setup (F10) Utility; Computer Setup (F10) Utilities - HP DC7600 - Utility Manual

Computer Setup (F10) Utilities

Computer Setup (F10) Utility Guide

Computer Setup (F10) Utility

Use Computer Setup (F10) Utility to do the following:
■
Change factory default settings.
■
Set the system date and time.
■
Set, view, change, or verify the system configuration, including
settings for processor, graphics, memory, audio, storage,
communications, and input devices.
■
Modify the boot order of bootable devices such as hard drives,
diskette drives, optical drives, or USB flash media devices.
■
Enable Quick Boot, which is faster than Full Boot but does not
run all of the diagnostic tests run during a Full Boot. You can set
the system to:
❏
always Quick Boot (default);
❏
periodically Full Boot (from every 1 to 30 days); or
❏
always Full Boot.
■
Select Post Messages Enabled or Disabled to change the display
status of Power-On Self-Test (POST) messages. Post Messages
Disabled suppresses most POST messages, such as memory
count, product name, and other non-error text messages. If a
POST error occurs, the error is displayed regardless of the mode
selected. To manually switch to Post Messages Enabled during
POST, press any key (except
■
Establish an Ownership Tag, the text of which is displayed each
time the system is turned on or restarted.
■
Enter the Asset Tag or property identification number assigned by
the company to this computer.
www.hp.com
F1 F12
through ).
1