HP DC7600 - Management Manual page 22

Desktop Management Guide
Ä
Ä
18
2. Insert the USB flash media device into one of the computer's
USB ports and remove all other USB storage devices except USB
diskette drives.
3. Insert a bootable DOS diskette with FDISK.COM and either
SYS.COM or FORMAT.COM into a diskette drive and turn on
the computer to boot to the DOS diskette.
4. Run FDISK from the A:\ prompt by typing
Enter. If prompted, click Yes (Y) to enable large disk support.
5
5. Enter Choice [ ] to display the drives in the system. The USB
flash media device will be the drive that closely matches the size
of one of the drives listed. It will usually be the last drive in the
list. Note the letter of the drive.
USB flash media device drive: __________
CAUTION: If a drive does not match the USB flash media device, do
not proceed. Data loss can occur. Check all USB ports for additional
storage devices. If any are found, remove them, reboot the computer, and
proceed from step 4. If none are found, either the system does not support
the USB flash media device or the USB flash media device is defective.
DO NOT proceed in attempting to make the USB flash media device
bootable.
6. Exit FDISK by pressing the
7. If your bootable DOS diskette contains SYS.COM, go to step 8.
Otherwise, go to step 9.
8. At the A:\ prompt, enter
letter noted above.
CAUTION: Be sure that you have entered the correct drive letter for the
USB flash media device.
After the system files have been transferred, SYS will return to
the A:\ prompt. Go to step 13.
9. Copy any files you want to keep from your USB flash media
device to a temporary directory on another drive (for example, the
system's internal hard drive).
10. At the A:\ prompt, enter
drive letter noted before.
www.hp.com
FDISK
Esc
key to return to the A:\ prompt.
SYS x:
where x represents the drive
FORMAT /S X:
where X represents the
Desktop Management Guide
and pressing