Table of Contents
Advertisement
WebPAM User Manual
3.
Click on the Enable radio button.
4.
Click on the by Day, by Week or by Month radio button.
5.
From the dropdown menus, select a start time and a day of the Week or
Month, if applicable.
Start time is based on a 24-hour clock.
6.
Click the Schedule button.
If you want to cancel the scheduled Synchronization, do the following:
1.
Click on the Logical Drive View
2.
Click on the Synchronization tab in Management View.
3.
Click on the Disable radio button.
Logical Drive Synchronization/Redundancy Check
Synchronization refers to an automated process of checking and correcting data
and parity. Unlike a Rebuild, Synchronization is a maintenance operation. You
can also synchronize all logical drives at the same time, see page 75.
Redundancy Check is an automated process of checking data and parity but it
only reports and does not correct, any inconsistencies that it finds.
Synchronization and Redundancy Check apply to RAID 1, RAID 5 and RAID 10
logical drives. When an logical drive is first created and you select Full
Initialization, the same action as Synchronization takes place.
You can set up a Synchronization or Redundancy Check to begin immediately
(on demand) or schedule a Synchronization or Redundancy Check for a time
when there is less demand on the RAID system.
On Demand
To Synchronize or Redundancy Check a logical drive:
icon in Tree View.
76
Advertisement
Table of Contents
