Log-Out Of Webpam; Internet Connection Using Webpam; Run Webpam Without Network Connection - Promise Technology dc5750 - Microtower PC User Manual

Log-out of WebPAM

There are two ways to log out of WebPAM:
• Close your browser window
• Click Logout on the WebPAM banner (below)
After logging out, you must enter your username and password to log in again.
Clicking Logout brings you back to the Login Screen.

Internet Connection using WebPAM

The above instructions cover connections between the Host PC and other PCs
using WebPAM over your company network. It is also possible to connect to a
Host PC from the Internet.
Your MIS Administrator can tell you how to access your network from outside the
firewall. Once you are logged onto the network, you can access the Host PC
using its IP address.
Please note that only the Host PC with the FastTrak RAID Controller can read
and write data to the logical drives. However, other PCs can monitor the Host PC
from virtually any location.

Run WebPAM without Network Connection

While WebPAM was designed to run over a network, you can run WebPAM
without a network connection but only from the Host PC. Follow this procedure:
1. Double-click the WebPAM desktop icon.
Your browser opens and displays a "no connection to the Internet is currently
available" message.
2. Click the Work Offline button.
3. In the WebPAM login screen, enter your user name and password (if used),
then click the Sign in button.
A "webpage unavailable while offline" message will display.
4. Click the Connect button.
A "no connection to the Internet is currently available" message will display.
5. Click the Try Again button.
After a few moments, WebPAM will display normally in your browser.
27
Chapter 3: Setup