Table of Contents
Advertisement
Click on a Physical Drive
Media Patrol Schedule
The Physical Drive View–Media Patrol tab allows you to start Media Patrol on all
physical drives. You can also run Media Patrol on individual physical drives, see
page 58.
Media Patrol is a routine maintenance procedure that checks the magnetic media
on each disk drive, sector by sector. Media Patrol checks physical drives
assigned to logical drives, spare drives and currently unassigned physical drives
that were once part of a logical drive or a spare. Media Patrol does not check new
physical drives that have never been configured nor physical drives assigned as
JBOD.
Unlike Synchronization and Redundancy Check, Media Patrol is concerned with
the condition of the media itself, not the data recorded on the media. If Media
Patrol encounters a suspect sector, it will attempt to regenerate the data and
write to the suspect sector. If the write operation is successful, Media Patrol
continues checking other sectors. If the write operation fails, Media Patrol reports
the error to your PC's system log and to the physical drive's Bad Sector Log (see
page 59). This action triggers a BSL update message and an email message if
you enabled that notification option (see page 38).
To schedule Media Patrol:
1.
Click on the Physical Drive View
2.
Click on the Media Patrol tab in Management View.
3.
Click on the Enable radio button.
4.
Click on the by Day, by Week or by Month radio button.
5.
From the dropdown menus, select a start time and a day of the Week or
Month, if applicable.
Start time is based on a 24-hour clock.
icon to see the results of your merge operation.
icon in Tree View.
55
Chapter 5: Monitor and Manage
Advertisement
Table of Contents
