1
SAS A connector
3
SAS backplane
5
Controller 0 connector
7
System board
9
SATA_A connector (on SAS
backplane)
RAID Battery
Installing a RAID Battery
1 Insert the RAID battery into the battery carrier. See Figure 3-13.
2 Locate the battery carrier slots at the left of the processors.
3 Place the controller cabling harnesses between the battery carrier clips and
the chassis.
4 Insert the battery carrier and RAID battery into the chassis battery carrier
slots ensuring that the battery carrier is aligned and fully seated in the
slots.
5 Connect the battery cable to the SAS controller card.
84
Installing System Components
2
GND/+12V connector
4
SAS B connector
6
Controller 1 connector
8
SATA_A connector (on system board)
10
Control panel connector