Dell PowerEdge XK946 Hardware Owner's Manual page 35

Table 1-6. System Messages
System Message
Warning: The current memory
configuration is not
validated. Change it to the
recommended memory
configuration or press any
key to continue.
Alert! Redundant memory
disabled! Memory
configuration does not
support redundant memory.
Attempting to update Remote
Configuration. Please wait...
Caution! NVRAM_CLR jumper is
installed on system board
CPUs with different cache
sizes detected
Decreasing available Memory
Diskette drive 0 seek failure Faulty or improperly inserted diskette,
Diskette read failure
Diskette subsystem reset
failed
Drive not ready
Corrective Action
This warning message will be displayed
when there is no any memory
configuration error, but the memory
configuration is not recommended by
Dell.
Redundant memory was set to enabled in
CMOS, but the current configuration
does not support redundant memory.
Remote Configuration request has been
detected and is being processed.
NVRAM_CLR jumper is installed.
CMOS has been cleared. NVRAM_CLR
jumper should be removed.
The system does not support running
with processors with mismatched cache
sizes
One or more DIMMs improperly seated
or faulty
incorrect configuration settings in System
Setup program, loose diskette/tape drive
interface cable, or loose power cable
Replace the diskette.
Faulty diskette, faulty or improperly
connected diskette/tape drive interface
cable, or loose power cable
Faulty diskette/tape drive controller
Diskette missing from or improperly
inserted in diskette drive
About Your System
35