Expansion-Card Stabilizer; Removing The Expansion-Card Stabilizer; Installing The Expansion-Card Stabilizer - Dell POWEREDGE E11S Owner's Manual

10 Exit the System Setup program and reboot the system.
11 Partition and logically format the drive.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.

Expansion-Card Stabilizer

Removing the Expansion-Card Stabilizer

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals. Disconnect the system from
the electrical outlet and peripherals.
2 Open the system. See "Opening the System" on page 45.
3 Press the release tab and lift the expansion card stabilizer out of slots in the
chassis. See Figure 3-15.

Installing the Expansion-Card Stabilizer

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Slide the edge of the expansion-card stabilizer into the slots in the cooling
shroud and chassis until the release tab locks into place. See Figure 3-15.
2 Close the system. See "Closing the System" on page 46.
Installing System Components
65