Installing The Front Bezel Insert; Emi Filler Panel; Removing An Emi Filler Panel - Dell POWERVAULT NX200 Hardware Owner's Manual

Installing the Front Bezel Insert

NOTE:
If you remove a drive from one or more of the front drive bays, replace the
corresponding insert(s) on the front bezel.
1 From the back of the bezel, align the insert tab with the corresponding
notch on the bezel. Press the insert until the tab snaps into place.
See Figure 3-3.
2 Replace the front bezel. See "Installing the Front Bezel" on page 76.

EMI Filler Panel

Depending on the configuration of your system, an electromagnetic
interference (EMI) filler panel may be installed in one or more of
the 5.25-inch optical drive bays at the front of the system. EMI filler panels
are essential for airflow efficiency and for EMI protection. To install an
optical drive, the corresponding EMI filler panel must first be removed.

Removing an EMI Filler Panel

1 Remove the front bezel. See "Removing the Front Bezel" on page 75.
2 Remove the EMI filler panel out of the chassis by pulling firmly on the
holes in the middle of the filler panel. See Figure 3-4.
Installing System Components
77