Dell POWERVAULT NX200 Hardware Owner's Manual page 30

Table 1-1. LCD Status Messages
Code Text
E1717 CPU #
internal
error. Review
& clear SEL.
E171F PCIe fatal
error on Bus
## Device ##
Function ##
E1810 Hard drive ##
fault. Review
& clear SEL.
E1812 Hard drive ##
removed.
Check drive.
E1A1D Control panel
USB cable not
detected.
Check cable.
E2010 Memory not
detected.
Inspect
DIMMs.
30
About Your System
(continued)
Causes
The system BIOS has
determined that the
processor has had an
internal error.
The system BIOS has
reported a PCIe fatal error
on a component that
resides in PCI
configuration space at
bus ##, device ##,
function ##.
The specified hard drive
has experienced a fault.
The specified hard drive
has been removed from
the system.
USB cable to the
control panel is
missing or bad.
No memory was
detected in the system.
Corrective Actions
Check the SEL for
more information, and
then clear the SEL.
Remove AC power to the
system for 10 seconds,
and restart the system.
If the problem persists,
see "Getting Help" on
page 157.
Remove and reseat the
PCIe expansion cards.
If the problem persists,
see "Troubleshooting
Expansion Cards" on
page 143.
See "Troubleshooting a
Hard Drive" on page 141.
Information only.
Reseat the cable. If the
problem persists,
replace cable.
If the problem persists,
see "Getting Help" on
page 157.
Install memory or reseat
the memory modules.
See "Installing Memory
Modules" on page 100 or
"Troubleshooting System
Memory" on page 137.