Removing and installing throttle-
valve stub pipe
Press in spring keeper of multi-pin plug for throt-
•
tle-valve potentiometer (1) and disconnect plug.
L
Note:
Do not remove throttle-valve potentiometer unless
due for replacement (basic setting is necessary —
see Motronic diagnosis instructions).
Remove the keeper (2) and screws (3).
•
Remove holder (4) with fuel line.
•
Remove fuel injector, if necessary.
•
Slacken hose clamps.
•
Push intake neck into air filter box and remove
•
throttle-valve stub.
13.6
6
2
e
Make sure that O-ring (5) on throttle-valve stub is in
perfect condition.
Disengage throttle cables (6) from right and left
•
throttle-valve stubs.
Installation is the reverse of the removal proce-
•
dure.
Adjusting speed increase, idle speed and synchro-
nisation
a
4
1
Caution:
....................................................See Group 00
3
5
S130020