Mrpp Troubleshooting - SMC Networks ES4704BD Manual

SWITCH G configuration Task Sequence:
Switch(Config)#MRPP enable
Switch(Config)#MRPP ring 100
Switch(MRPP-ring-100)#control-vlan 100
Switch(MRPP-ring-100)#primary-port Ethernet 1/1
Switch(MRPP-ring-100)#secondary-port Ethernet 1/2
Switch(MRPP-ring-100)#node-mode master
Switch(MRPP-ring-100)#enable
Switch(MRPP-ring-100)#exit
Switch(Config)#

22.5 MRPP troubleshooting

The normal operation of MRPP protocol depends on normal configuration of each
switch on MRPP ring, otherwise it is very possible to form ring and broadcast storm:
Configuring MRPP ring, you'd better disconnected the ring, and wait for each switch
configuration, then open the ring.
When the MRPP ring of enabled switch is disabled on MRPP ring, it ensures the ring
of the MRPP ring has been disconnected.
When there is broadcast storm on MRPP ring, it disconnects the ring firstly, and
ensures if each switch MRPP ring configuration on the ring is correct or not; if correct,
restores the ring, and then observes the ring is normal or not.
In normal configuration, it still forms ring broadcast storm or ring block, please open
debug function of primary node MRPP, and used show MRPP statistics command to
observe states of primary node and transfer node and statistics information is normal or
not, and then sends results to our Technology Service Center.
847