Ip Igmp Snooping Vlan Mrpt; Ip Igmp Snooping Vlan Query-Interval - SMC Networks ES4704BD Manual

Parameter: vlan-id: ranging between <1-4094>
ehternet: Name of Ethernet port
ifname: Name of interface
port-channel: Port aggregation
Command Mode: Global mode
Default: No static mrouter port on vlan by default.
Usage Guide: When a port is a static mrouter port while also a dynamic mrouter port, it
should be taken as a static mrouter port. Deleting static mrouter port can only be realized
by the "no
ip
(<ehternet>|<ifname>|<port-channel>)" command.
Example: Switch(config)#ip igmp snooping vlan 2 mrouter-port interface ethernet

15.3.6 ip igmp snooping vlan mrpt

Command: ip igmp snooping vlan <vlan-id> mrpt <value>
no ip igmp snooping vlan <vlan-id> mrpt
Function: Configure this survive time of mrouter port
Parameter: vlan-id: vlan id , ranging between <1-4094>
value: mrouter port survive period, ranging between <1-65535>seconds
Command Mode: Global mode
Default: 255s
Usage Guide: This command validates on dynamic mrouter ports but not on mrouter
port. To use this command, IGMP Snooping of this vlan should be enabled previously.
Example: Switch(config)#ip igmp snooping vlan 2 mrpt 100

15.3.7 ip igmp snooping vlan query-interval

Command: ip igmp snooping vlan <vlan-id> query-interval <value>
no ip igmp snooping vlan <vlan-id> query-interval
Function: Configure this query interval
Parameter: vlan-id: vlan id , ranging between <1-4094>
value: query interval, ranging between <1-65535>seconds
Command Mode: Global mode
Default: 125s
Usage Guide: It is recommended to use the default settings. Please keep this configure
in accordance with IGMP configuration as possible if layer 3 IGMP is running.
Example: Switch(config)#ip igmp snooping vlan 2 query-interval 130
igmp snooping vlan <vlan-id>
605
mrouter-port interface