Lldp Hold; Lldp Delay - SMC Networks 8028L2 - annexe 1 Management Manual

| LLDP Commands
C 18
HAPTER

lldp hold

lldp delay

E
XAMPLE
LLDP>interval 60
LLDP>
This command displays or sets the TTL value sent in LLDP advertisements.
S
YNTAX
lldp hold [hold]
hold - The time-to-live (TTL) value sent in LLDP advertisements as
shown in the formula below. (Range: 2-10)
TTL in seconds is based on the following rule:
(Transmission Interval * Transmission Hold Time) ≤ 65536.
Therefore, the default TTL is 30*3 = 90 seconds.
D S
EFAULT ETTING
3
C U
OMMAND SAGE
The time-to-live tells the receiving LLDP agent how long to retain all
information pertaining to the sending LLDP agent if it does not transmit
updates in a timely manner.
E
XAMPLE
LLDP>hold 10
LLDP>
This command displays or sets the delay between the successive
transmission of LLDP advertisements.
S
YNTAX
lldp delay [delay]
delay - The delay between the successive transmission of
advertisements initiated by a change in local LLDP MIB variables.
(Range: 1-8192 seconds)
This attribute must comply with the rule:
(4 * Transmission Delay) ≤ Transmission Interval
D S
EFAULT ETTING
2 seconds
– 286 –