SMC Networks -GT1255FTX-SC User Manual page 15

125 micron multimode fiber optic cabling. Because SC
connections are keyed, they can only be attached in one
orientation. Connect one end of the fiber cable to the card's SC
connector and the other end of the cable to the fiber connector
on the other device. Make certain that the device you are
connecting to is specified for 100 Mbps operation.
Figure 2. Connecting the SC connector
6. Replace the computer's cover and power it on. The
SMC1255FTX-SC should be automatically configured by the
host computer's BIOS. However, if you have an older
computer, you may have to manually configure the computer's
BIOS settings.
The RJ-45 connector supports auto-negotiation, so the port can
configure itself automatically to run at the highest possible data
transfer rate (10 or 100 Mbps and half or full duplex) providing
the link partner also supports Auto-Negotiation. The SC fiber
connector enables the SMC1255FTX-SC model to support 100
Mbps transmissions at full and half duplex over 62.5/50/125
micron multimode fiber cable. A fiber cable link operating in
full-duplex mode can extend to remote sites up to 2 km (1.24
miles) away.
H I
ARDWARE NSTALLATION
5