Pci Configuration - SMC Networks -GT1255FTX-SC User Manual

I
NSTALLING THE
7. This model supports a Wake-On-LAN connector. The
Wake-On-LAN (WOL) cable allows a WOL-enabled PC to be
managed remotely. Software can be loaded and updated,
configurations changed, data backed up, inventory checked,
viruses removed, and device conflicts eliminated. This
decreases user downtime and increases overall productivity.
For using the WOL function, connect one end of the 3-pin
WOL cable to connector J1 on the card, and the other end to
the "5V Standby" connector on the computer's motherboard, as
shown in the following figure. (Refer to your computer's
installation manual to locate the 5V Standby connector.)
Figure 3. Attaching the Wake-On-LAN Cable

PCI Configuration

In most cases, your network card is automatically configured when
you power-up your computer. In certain computers, however, you
must modify your BIOS by entering your CMOS SETUP utility. For
more information, refer to "PCI Compatibility" on page 27.
6
C
ARD
Wake-On-LAN Cable
J1
" 5V Standby" Connector