Table of Contents
Advertisement
Activating the radio display and selecting a source
When the navigation system is on:
Via the RC 5400:
Press ENTERTAIN.
:
The main menu of the RM 8204 will appear.
Using the cursor buttons, select the required source (TUNER, CDC/DVDC or AUX)
and confirm it with OK.
The remote control can also be used to call up the navigation module or a tele-
phone connected to this module.
If no further button is pressed in the next 5 seconds, the unit switches automatically
to the previous video source (for instance, navigation window). This automatic swit-
chover can be deactivated via the timer activation / deactivation function.
Via the keypad of the MM 5600:
Press the O button.
:
The main menu of the RM 8204 will appear.
Pressing the O button again selects the next source in each case. Explicit confirma-
tion is not required here.
If no further button is pressed in the next 5 seconds, the unit switches automatically
to the previous video source (for instance, navigation window). This automatic swit-
chover can be deactivated via the timer activation / deactivation function.
'Busy' display
While the system is busy, the cursor is displayed in grey. Only once the cursor has
regained its normal colour is the user interface enabled again.
Volume adjustment
Press the W or V button to set the volume.
If the button is held down, the volume changes continuously.
A
When setting the volume, please make sure that traffic noises (horns, sirens, emer-
gency vehicles, etc.) are still audible.
MUTE function
Press the LS button.
:
This mutes the radio.
Press the LS button again to deactivate the muting function.
The muting function can also be deactivated by adjusting the volume with the
W or Vbutton.
If the muting function is activated during CD playback, the CD changer stops at the
current CD location.
Video / audio signals during driving*
For reasons of driving safety, video images following selection of the AUX or DVDC
source are only displayed when the hand brake is applied.
* Prerequisite: The RM 8204 must be connected to a video source or DVD changer, and
the input for the AUX or DVD changer signals must have been enabled in the SETUP
menu.
Operation
7
Advertisement
Table of Contents
