Dvd Changer; Aux Input (Audio / Video Source); Sound Menu - VDO RM 8204 Installation And Owner's Manual

Hide thumbs Also See for RM 8204:

Table of Contents

DVD changer

(accessory)

If, instead of a CD changer, a DVD changer is connected to the RM 8204, selecting

DVDC in the main menu effects a switchover to playback via this device.

The DVD changer's basic functions (start, stop, search etc.) can be controlled via the

RC 5400 or the MM 5600 as described in the section on the CD changer.

If the hand brake has been applied, the DVD changer's video signal is output auto-

matically on the screen. While the vehicle is moving, the video signal remains disab-

led for safety reasons, although the audio signal remains effective.

To permit full use of the DVD changer's functionality, this device should be opera-

ted via its own remote control (for this purpose, an external infrared receiver must

be connected to the DVD changer).

The DVD changer needs to be activated in the SETUP menu (refer to configuration

of the CD / DVD changer).

Select "AUX" in the main menu in order to set the AUX input as the source.

If a video source has been connected to the RM 8204, its video and audio signals

will be output.

For safety reasons, the video signal is only output if the hand brake has been

applied.

To make the AUX input available, the AUX option must have been activated in the

SETUP menu.

If a DVD changer has been connected, the AUX input receives purely audio signals.

Select "SND" in the main menu in order to open the sound sub-menu.

Select bass, treble, balance, fader or loudness.

Press OK to confirm your selection.

Adjust the sound as required with the cursor buttons 8 and 2.

Press OK to confirm your settings.

To exit the menu, select "ESC" or press the ESC button.

Adjustment ranges:

Bass, treble: -9 to +9

Balance: LEFT +9 ... MIDDLE ... RIGHT +9

Fader: FRONT +9 ... MIDDLE ... REAR +9

Loudness: ON ... OFF

Operation

Table of Contents