Aiwa XR-MT1000 Operating Instructions Manual page 37

Aiwa compact disc stereo system user's manual model no. xr-mt1000
Hide thumbs Also See for XR-MT1000:
Table of Contents

Advertisement

Available languages

Available languages

[f the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
Thlere is no sound.
Is the AC cord connected properly?
Is there a bad connection? (+ page 5, 6)
There may be a short circuit in the speaker terminals.
-+ Disconnect
the AC cord,
then correct
the speaker
connections.
VVasan incorrect function button pressed?
Scmrnd is emitted from one speaker only.
" Is the other speaker disconnected?
The output sound is not stereo.
Is the Karaoke function turned on? (+ page 23)
An erroneous display or a malfunction
occurs.
-+ Reset the unit. See "To reset".
STEREO RECEIVER
There is constant, wave-like static.
l:; the antenna connected properly? (+ page 6, 7)
" Is the signal weak?
-+ Connect an outdoor antenna.
The reception contains noise interferences
or the sound
is distorted.
Is the system picking up external noise or multipath distortion?
-+ Change the orientation of the antenna.
-+ Move the unit away from other electrical appliances.
CASSETTE
DECK
The tape does not run.
c Is deck in pause mode? (+ page 29)
The sound is off-balance
or not adequately
high.
Is the playback head dirty? (+ page 36)
Recording
is not possible.
Is the erasure prevention tab on the tape broken off? (+ page
30)
Is the recording head dirty? (+ page 36)
Erasure is not possible.
Is the erasure head dirty? (+ page 36)
Is a metal tape being used?
High frequency sound is not emitted.
Is
the recording/playback head dirty? (+ page 36)
Is a tape recorded without Dolby NR played back with the Dolby
PJRsystem operating? (-$ page 29)
To reset
If an unusual condition occurs in the display windows or the
cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press POWER to turn the power back on while pressing
SET. Everything stored in memory after purchase is
canceled.
If the power cannot be turned off in step 1 because of a
malfunction, disconnect the AC cord. Then connect it again
and carry out step 2.
POWER
o receiver
CD PLAYER
The CD player does not play.
Is the disc correctly placed? (+ page 24)
Is the disc dirty? (+ page 36)
s Is the lens affected by condensation?
-+ Wait approximately one hour and try again.
ENGLISH
37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents