Aiwa XR-MT1000 Operating Instructions Manual page 35

5.1 CH INPUT jacks of the MX-NMTIOOO support the DOLBY
DIGITAL SURROUND system.
Connect a DVD player with 5.ICH output jacks to this unit using
caties with RCA phono plugs as follows;
DVD player's jack
This unit's jack
5.I19H OUTPUT FRONT (L,R), etc. ~ 5.1 CH FRONT (L,R)
5.1CH OUTPUTSURROUND (L,R), etc. ~ 5.lCH SURROUND(L,R)
5.ICH OUTPUT CENTER, etc. ~ 5.ICH CENTER
5.1CH OLJTpLIT SUB WOOFER, etc. - 5.ICH SUB WOOFER
LINE OUT (L, R), etc. ~ VIDEO/AUX
(See =.)
Em
If the DVD player is not connected to VI DEO/AUX jacks of this
unit;
- the spectrum analyzer dose not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
TO remove these limitations, connect the LINE OUT jacks of
the DVD player to VIDEO/AUX jacks of this unit besides
connecting to 5.ICH INPUT jacks. The signals through VIDEO/
AUX jacks enable the spectrum analyzer to work and the
recording to be done.
Refer also to the operating Instructions of the DVD player.
. DOLBY DIGITAL SURROUND sound cannot be recorded in
any way.
SURROUND SOUND
i
MANUAL
SELECT
1
++ DOWN,
*UP
When a DVD player is connected to the 5.1 CH INPUT jacks of
the MX-NMTIOOO, you can listen to DOLBY DIGITAL
SURROUND sound, which enables you to enjoy theater-quality
sound in your home.
1
2
Press VIDEO/AUX/5.l CH repeatedly until "5.1 ch
IN" is displayed.
Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
m
The DOLBY PRO LOGIC, BBE and the SURROUND are
automatically canceled when the 5.1 CH is selected.
Make sure the software played back with the connected DVD
player support the DOLBY DIGITAL SURROUND
The function is changed from the 5.1 CH to the VIDEO when;
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the Rhythm play function, the SURROUND system, the
DOLBY PRO LOGIC or the Karaoke function is turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
1 Press VI DEO/AUX/5.l CH repeatedly until "5.1 ch IN" is
displayed.
2 Press MANUAL SELECT (TEST) repeatedly.
Speaker names appear in turn as follows;
~ L>R (Speaker balance)—
CEN' Center'peaker 1 m
Ls.R:
Right s urround speaker+
S-L:
Left surround speakerd
3 Press < DOWN or FP UP to adjust the sound level while
"CEN", "S-L" or "S-R is displayed.
Each level can be adjusted between -8 dB and +7 dB.
4 Repeat steps 2 and 3 to adjust each speake"r's sound level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the SURROUND
system (page 12) and the DOLBY PRO LOGIC (page 15) is also
changed.
ENGLISH
35