SRAM DUALDRIVE Manual page 13

M A I N T E N A N C E A N D C A R E
C A B L E C H A N G E
» Feed the cable through the new
cable housing and frame stops.
» Attach cable to the derailleur and
adjust indexing.
Thumb shifter (gear hub):
Place thumb shift lever
7
in hill riding mode.
» Remove Clickbox from the axle
(see Page 10).
Snap open Clickbox-cover (6)
15
as shown.
» Unscrew clamping bolt (7), hex
wrench 4 mm.
Remove the shifter escape
14
hatch (4).
» Remove and discard the old cable.
» Feed the new cable through the
cable entry (5), the new cable
housing and pull the cable snug.
» Attach the escape hatch.
Pull the cable tight and
15
position it under the cable
anchor washer (8).
» Tighten the 4 mm hex cable anchor
bolt to 2.5 – 4 Nm (22 – 35 in.lbs.).
» Cut off cable end to 1 – 2 mm.
» Snap in Clickbox-cover.
DualDrive · December 2002
» Install Clickbox (see Page 10).
» Adjust gearshift.
15
7
6
R E P A I R W O R K
Arrange for any work, which
may become necessary on
the DualDrive gear hub and shifter
to be carried out by your qualified
specialist dealer.
» Non-authorized work on your
DualDrive system could put you in
danger and also lead to the loss of
your guaranteed rights.
» If you have questions or problems
please contact your qualified
specialist dealer.
8
4 mm
2.5 – 4 Nm
22 – 35 in.lbs.
13
E