Table of Contents
Advertisement
Figure 16 Device > Registration > Wizard Choices
3.3.1 Manual Option
Use the following screen to enter device information, get device configurations and set
encryption options.
You do not need to add NAT or firewall rules when you encrypt this traffic.
3.3.1.1 Configuring ZyXEL Device using Commands
To set the encryption mode on the ZyXEL device, do the following:
1 Go to CI (Command Interface) mode (SMT 24.8 for devices with SMT menus).
2 Type 'CNM encrymode X' where:
3 To set the encryption key on the ZyXEL device, type 'CNM encrykey xxxxxxxxx' where
'xxxxxxxxx' is the alphanumeric encryption key ("0" to "9", "a" to "z" or "A" to "Z") in
the Vantage server.
3.3.1.2 Configuring ZyXEL Device using Web Configurator
To set the encryption mode on the ZyXEL device, do the following:
Log into the device web configurator, click Remote Management from the navigation panel
and then click the CNM tab. Select Enable, (enter the Vantage CNM Server (IP) Address)
and enter an Encryption Algorithm and Encryption Key.
Chapter 3 Device Menus
Value of X
Encryption Mode
0
None
1
DES
2
3DES
Vantage CNM 2.0 User's Guide
48
Advertisement
Table of Contents
