Gui-Based Tftp Clients; Restore Configuration; Restore Using Ftp; Table 134 General Commands For Gui-Based Tftp Clients - ZyXEL Communications P-335WT User Manual

P-335 Series User's Guide

35.2.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 134 General Commands for GUI-based TFTP Clients

COMMAND
Host
Send/Fetch
Local File
Remote File
Binary
Abort

35.3 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.

35.3.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter
376
DESCRIPTION
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file
(*.rom extension) on your computer.
This is the filename on the Prestige. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
Note: WARNING! Do not interrupt the file transfer process as this
may PERMANENTLY DAMAGE YOUR Prestige.
Chapter 35 Firmware and Configuration File Maintenance