Roaming; Figure 43 Roaming; Table 35 Roaming - ZyXEL Communications P-335WT User Manual

Table 34 MAC Address Filter
LABEL
MAC Address Enter the MAC addresses of the wireless station that are allowed or denied access to
Apply
Reset

7.6 Roaming

See the appendix for background information on roaming.
To enable roaming on your Prestige, click the WIRELESS link under ADVANCED and then
the Roaming tab. The screen appears as shown.

Figure 43 Roaming

The following table describes the labels in this screen.

Table 35 Roaming

LABEL
Active
Port
Apply
Reset
Chapter 7 Wireless LAN (P-335WT)
DESCRIPTION
the Prestige in these address fields. Enter the MAC addresses in a valid MAC address
format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Select Yes from the drop-down list box to enable roaming on the Prestige if you have
two or more Prestiges on the same subnet.
Note: All APs on the same subnet and the wireless stations must
have the same SSID to allow roaming.
Enter the port number to communicate roaming information between APs. The port
number must be the same on all APs. The default is 3517. Make sure this port is not
used by other services.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
P-335 Series User's Guide
123