ZyXEL Communications FSG1100HN User Manual page 17

The following table describes the LEDs and the WPS button.
Front Panel LEDs and WPS Button
LED
Power
WAN
WLAN/WPS
Internet
FSG1100HN User's Guide
COLOR STATUS DESCRIPTION
Green On
Off
Red On
Green On
Blinking
Off
Green On
Blinking
Off
Orange Blinking
Green On
Blinking
Chapter 2 The WPS Button
The FSG1100HN is receiving power and
functioning properly
The FSG1100HN is not receiving power.
A system error has occurred.
The FSG1100HN has a successful
10/100Mbps WAN connection.
The FSG1100HN is sending/receiving data
through the WAN.
The WAN connection is not ready, or has
failed.
The FSG1100HN is ready, but is not
sending/receiving data through the wireless
LAN.
The FSG1100HN is sending/receiving data
through the wireless LAN.
The FSG1100HN is negotiating a WPS
connection with a wireless client.
The FSG1100HN is not ready or has failed.
The FSG1100HN's WPS connection is being
configured.
The FSG1100HN's IP is connected (the
device has a WAN IP address from IPCP or
DHCP and fiber is linked or a static IP
address is configured, PPP negotiation has
successfully completed – if used – and fiber is
linked) and no traffic is detected. If the IP or
PPPoE session is dropped due to an idle
timeout, the light will remain green if a fiber
connection is still present. If the session is
dropped for any other reason, the light is
turned off. The light will turn red when it
attempts to reconnect and DHCP or PPPoE
fails.
The FSG1100HN's IP is connected and IP
traffic is passing through the device (either
direction), flashing at 4 Hz with a 50% duty
cycle.
17