Activating Spanning Tree Protocol; Configuring Spanning Tree Parameters; Figure 10-1 Activating Stp; Figure 10-2 Configure Spanning Tree Parameters - ZyXEL Communications Dimension ES-2008 User Manual

Ethernet switch
Table of Contents

Advertisement

Dimension ES-2008 Ethernet Switch

10.2 Activating Spanning Tree Protocol

Use the Switch Configuration screen to activate STP on the switch.
Step 1.
Click Administrator, Switch Configuration and then the Advanced tab.
Step 2.
Select the Enable STP Protocol check box under Protocol Enable Settings:.
Step 3.
Click Apply to save the changes.

10.3 Configuring Spanning Tree Parameters

To configure STP on the switch, click Administrator and then Spanning Tree.

Figure 10-2 Configure Spanning Tree Parameters

The following table describes the related fields to configure on a global basis (for the
entire switch).
FIELD
Priority
To set the priority of this switch in a spanning tree, enter a
number between 1 and 65535.
A higher value indicates a lower priority; thus 0 means the
highest priority. The default is 32768.
10-2

Figure 10-1 Activating STP

Table 10-2 Configure STP Parameter

DESCRIPTION
EXAMPLE
32768
Spanning Tree Protocol

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents