Figure 18-3 Smt: Firmware Upload Process; Figure 18-4 Web Configurator: Firmware Upgrade - ZyXEL Communications Dimension ES-2008 User Manual

Ethernet switch

Table of Contents

$$$ Switch LOADER Checksum O.K !!!

$$$ Press X key to

$$$ Download IMAGE through console(1K Xmodem;baudrate=57600bps)

$$$ Start Xmodem Receiver: CCCCCCCCC

$$$ Download IMAGE .... O.K !!!

$$$ Update firmware . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . .

$$$ Update Firmware . . . . OK!!!

$$$ Note: console baudrate of new image is 9600bps..

$$$ Reboot . . . .

Step 6.

After the firmware upload process has completed, the switch will

automatically restart. You must change the console port rate back to 9600bps.

Step 7.

Check the System Information screen to confirm that you have uploaded the

correct firmware version.

18.2.2 Firmware Upgrade Using the Web Configurator

Follow the steps below to upgrade firmware via the web configurator.

Step 1.

Follow the steps in the Accessing the Web Configurator section to log in to the

web configurator.

Step 2.

Run a TFTP server program on the computer and specify the location of the

firmware file and the communication mode.

Step 3.

Click TFTP Update Firmware to display the screen as shown next.

Figure 18-4 Web Configurator: Firmware Upgrade

Step 4.

Enter the IP address of the TFTP server, where the new firmware file resides,

in the TFTP Server IP Address field.

Step 5.

Specify the name of the firmware file in the Firmware File Name field. The

firmware filename must not be more than 15 ASCII characters and must be

exactly the same as the firmware file on the computer.

Firmware and Configuration File Maintenance

start Xmodem receiver: Key = 78