Input Signal (For Pc Input Mode); Digital Noise Reduction; Audio Only; Audio Only - Sharp AQUOS LC-26GA4U Operation Manual

Useful adjustment settings

Input signal (for PC input mode)

• Some input signals may have to be registered manually
to display properly.
• The pairs of input signals (resolutions) in the list below
are not distinguishable when received. In such case, you
have to set the correct signal manually. After setting once,
it will display when the same signal (resolution) is input
again.
640g400
640g480
1024g768
NOTE
• You can only select the "Input Signal" on the Setup menu
when receiving one of the 6 input signals listed above.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Input Signal" and then
press ENTER.
4
Press a/b to select the desired input signal
on the display.
720g400
848g480
1280g768
Example
640 x 480
848 x 480

Digital Noise Reduction

Produces a clearer video image.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Option".
3
Press a/b to select "Digital Noise
Reduction", and then press ENTER.
4
Press a/b to select the desired level, and
then press ENTER.

Audio only

When listening to music from a music program, you
can set the display off and enjoy audio only.
1
Repeat steps 1 and 2 in Digital Noise
Reduction.
2 Press a/b to select "Audio Only", and then
press ENTER.
3
Press c/d to select "On", and then press
ENTER.
Selected item
On Audio is output without screen image.
Off
Both screen images and audio are output.
Off
High
Low
Description
59