Print Size - SATO M-8400RV Operator And Technical Reference Manual

Section 2. Installation and Configuration
If LARGE was selected, a label containing a head check pattern and the current
printer setting information will be printed.
2. Once the desired label size setting is underlined, pressing the FEED key will cause
a label to be printed if LARGE was underlined. If SMALL was underlined, the
display will advance to the Print Size display.

Print Size

If SMALL was selected, the Print Size message will be displayed. You must enter the
size of the label. The minimum label size that can be selected is 4 cm (1.6") and the
maximum size is 10 cm (4").
Pressing the LINE key will increment the setting by 1 cm for each time the key is
pressed. Once the maximum size is reached, the display will wrap arond and start
incrementing at 04 cm again. Once the correct label width is selected, pressing the
FEED key will initiate the print. The SMALL label only contains a head check pattern.
If you wish to pause the printer after its starts to print a test label, press the LINE key
to place it Off Line. Pressing the LINE key again will palce the printer back On Line
and the test label will resume printing. If you wish to stop the test label print, pause
the printer and then turn power off without placing it On Line.
Page 2-32
USER TEST PRINT
LARGE
PRINT SIZE
9001041 Rev. D
SMALL
04 cm
SATO M-8400RV