Appendix D: Optional Accessories; Label Rewinder - SATO M-8400RV Operator And Technical Reference Manual

INTRODUCTION
This section contains instructions for using the following M-8400RV optional features:

Label Rewinder

Label Cutter
Label Dispenser
PCMCIA Memory Cards
Calendar
LABEL REWINDER
The rewinder is an external unit that allows for labels and tags to be rewound in rolls
up to 8.5 inches in diameter. It derives its power directly from the printer's EXT
connector using a built-in cable. The rewinder provides the ability to rewind
tags/labels from the printer and subsequently be unwound for later use with
applicators.
Installation
1. Position the
(The
2. Connect the built-in cable from the
the printer.
3. On the
4. Feed the lead end of the label stock under the first spindle and onto the
over the label stock. Wind another revolution to ensure the labels are secure on
the spindle.
5. Select the REWIND option on the rewinder, then set the power switch to ON. (The
printer must be powered ON for the rewinder to function.)
Removing and Unwinding the Roll
As labels are printed, tension from the rewinder should keep the label stock taut as it
wraps itself on the spindle.
To remove the roll from the spindle, first set the power switch to OFF. Remove the
metal clamp, then remove the rewound roll of labels.
SATO M-8400RV
APPENDIX D.
OPTIONAL ACCESSORIES
at the front of the printer and align it with the label slot.
, remove the metal clamp from the
. Feed the stock around the spindle once, then replace the metal clamp
9001041 Rev. D
should be positioned away from the printer.)
to the EXT connector at the rear of
.
Page D-1