SATO M-8400RV Operator And Technical Reference Manual page 224

Appendix C: Custom Characters and Graphics
3. Transfer the image into two bit map representations and then into hexadecimal or
binary format.
4. To store the custom designed character in memory using a hexadecimal data
stream, the command would be:
<ESC>A
<ESC>T1H3F0100038007C00FE01FF03FF87FFCFFFE07C007C007C007C007C007C007C007C0
<ESC>Z
Note: This should be a continuous data string without any CR or LF characters.
5. To recall the custom character from memory, send the following code to the
printer. Note that you can print other data as well. Also note how the character size
was expanded using the <ESC>L command.
<ESC>A
<ESC>L0505<ESC>H0150<ESC>V100<ESC>K1H903F
<ESC>L0505<ESC>H0600<ESC>V100<ESC>K1H903F
<ESC>L0303<ESC>H0125<ESC>V0250<ESC>MTHIS SIDE UP !
<ESC>Q1
<ESC>Z
6. To store the custom designed character in memory using a binary data stream, the
command would be:
<ESC>A
<ESC>T1B3F 01
07 C0
H H
<ESC>Z
NOTE: Spaces are shown between hexidecimal values in the above example for clarity only and
are not included in the data string.
Page C-2
ROW BIT MAP
1 0000 0001 0000 0000
2 0000 0011 1000 0000
3 0000 0111 1100 0000
4 0000 1111 1110 0000
5 0001 1111 1111 0000
6 0011 1111 1111 1000
7 0111 1111 1111 1100
8 1111 1111 1111 1110
9 0000 0111 1100 0000
10 0000 0111 1100 0000
11 0000 0111 1100 0000
12 0000 0111 1100 0000
13 0000 0111 1100 0000
14 0000 0111 1100 0000
15 0000 0111 1100 0000
16 0000 0111 1100 0000
00 03 80 07
H H H H H
07 C0 07 C0 07 C0
H H H H H
0
)
9001041 Rev. D
HEX
01 00
03 80
07 C0
0F E0
1F F0
3F F8
7F FC
FF FE
07 C0
07 C0
07 C0
07 C0
07 C0
07 C0
07 C0
07 C0
C0 0F E0 1F F0 3F
H H H H H
07 C0 07 C0 07
H H H H H H
F8 7F FC FF FE
H H H H H H
C0 07 C0
H H H
SATO M-8400RV