Connecting Control Cords; About Sr - Pioneer PDP-4270HD Operating Instructions Manual

Enjoying through External Equipment

Connecting control cords

Connect control cords between the Plasma Display and other
PIONEER equipment having the
the connected equipment by sending commands from its
remote control unit to the remote control sensor on the Plasma
Display.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Display when operating the connected equipment.
NOTE
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.

About SR+

The CONTROL OUT terminal on the rear of the Plasma Display
supports SR+, which allows linked operations with a PIONEER
AV receiver. SR+ presents functions such as the input switch
linkage operation function and the DSP surround mode display
function. For more information, see the instruction manual
that came with the PIONEER AV receiver supporting SR+.
NOTE
• When making control cord connections, use the SR+ cable.
• When making control cord connections with one or more
pieces of Pioneer equipment, directly connect the Plasma
Display and the Pioneer amplifier that supports SR+. Do not
connect other equipment between them.
• When the connected equipment is being operated using
SR+, the volume on the Plasma Display System is
temporarily reduced.
logo. You can then operate
Plasma Display (rear view)
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
When SR+ is not used:
The control cables (commercially
available) are mono sound cables with
mini plugs (no resistance).
When SR+ is used:
Use the SR+ cable (available as option).
12
77
En