Connecting Control Cords; About Sr - Pioneer PDP-4360HD Operating Instructions Manual

Enjoying through External Equipment

Connecting control cords

Connect control cords between the Media Receiver and other
PIONEER equipment having the
the connected equipment by sending commands from its
remote control unit to the remote control sensor on the Plasma
Display.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Display when operating the connected equipment.
NOTE
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.

About SR+

The CONTROL OUT terminal on the rear of the Media Receiver
supports SR+, which allows linked operations with a PIONEER
AV receiver. SR+ presents functions such as the input switch
linkage operation function and the DSP surround mode display
function. For more information, see the instruction manual
that came with the PIONEER AV receiver supporting SR+.
NOTE
• When the connected equipment is being operated using
SR+, the volume on the Plasma Display System is
temporarily reduced.
logo. You can then operate
Media Receiver (rear view)
G-LINK
CONTROL ANT/
CABLE A IN
INPUT 3
MONITOR
OUT
INPUT 2
ANT B
I N OUT IN
R-AUDIO-L VIDEO S-VIDEO
SERVICE ONLY
CONTROL
INPUT 1
I N OUT
CONTROL
The control cables (commercially
available) are mono sound cables with
mini plugs (no resistance).
S400
(TS)
OPTICAL
Cable CARD
R-AUDIO-L DIGITAL OUT
SUB WOOFER
Y C / P C / P
B B R R
INPUT 1 INPUT 3 BLACK WH
COMPONENT
VIDEO SYSTEM CABLE
HDMI
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
12
77
En