Ip Control Setting - Pioneer Kuro KRP-500M Operating Instructions Manual

Use Other Equipment With Your Flat Panel Display
06
6.8.1

IP Control Setting

To apply the IP Control Setting, follow the directions below.
1 ) Access
2 ) Select IP Control from the IP Control Setting menu.
3 ) Select Enable from the IP Control menu.
Note: The default IP Control menu is Disable.
Confirm the IP Address
Enter DHCP , IP Address, Subnet Mask, Default Gateway and LED.
1 ) Access IP Control Setting through the Control Setup menu
2 ) Select
3 ) Select
If you select On, an IP Address is automatically acquired.
If the panel fails to assign the IP Address or if you want to obtain different addresses, select Off in Step 3
then enter an IP Address and Subnet Mask.
4 ) Press RETURN to make your selection.
5 ) Select LED from the IP Control Setting menu.
6 ) Select On or Off from the submenu.
Selecting On causes the LAN terminal indicator to light while in use.
7 ) Press EXIT to exit the menu.
68
En
IP Control Setting through the
IP Control Setting
IP Control
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
LED
KURO LINK Setting
Input Setting
Power Off Control
Power On Ready
Hold Sound Status
Power On Test
Power Off Test
Serial Setting
ID No. Set
Baud Rate
Exit
DHCP
from the IP Control Setting menu.
On Off
or from the submenu.
Control Setup menu .
Control Setup
: Disable
: Off
: On
: Off
: Off
: Off
: Off
: Off
: Off
: All
: 9600bps
.