Table of Contents
Advertisement
Use Other Equipment With Your Flat Panel Display
06
6.8.1
IP Control Setting
To apply the IP Control Setting, follow the directions below.
1 ) Access
2 ) Select IP Control from the IP Control Setting menu.
Enable
3 ) Select
Note: The default IP Control menu is Disable.
Confirm the IP Address
Enter DHCP , IP Address, Subnet Mask, Default Gateway and LED.
1 ) Access
2 ) Select
DHCP
3 ) Select
On
If you select On, an IP Address is automatically acquired.
If the panel fails to assign the IP Address or if you want to obtain different addresses, select Off in Step 3 then
enter an IP Address and Subnet Mask.
4 ) Press RETURN to make your selection.
5 ) Select
LED
On
6 ) Select
Selecting On causes the LAN terminal indicator to light while in use.
7 ) Press EXIT to exit the menu.
64
En
IP Control Setting
through the
IP Control Setting
IP Control
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address
LED
KURO LINK Setting
Input Setting
Power Off Control
Power On Ready
Hold Sound Status
Power On Test
Power Off Test
Serial Setting
ID No. Set
Baud Rate
Exit
from the IP Control menu.
IP Control Setting
through the
from the IP Control Setting menu.
or
Off
from the submenu.
from the IP Control Setting menu.
Off
or
from the submenu.
Control Setup
.
menu
Control Setup
:
Disable
:
Off
:
On
:
Off
:
Off
:
Off
:
Off
:
Off
:
Off
:
All
:
9600bps
Control Setup
menu
.
Hide quick links:
Advertisement
Table of Contents
