Adjust The Output Level From The Speakers (Gain Setting) - Pioneer DV-AX10 Operating Instructions Manual

Adjust the Output Level from the Speakers (Gain Setting)

1 Audio2 Video Language
Audio DRC – Off
Audio Out – 2 Channel
Speaker Setting
Gain Setting
Hi-Brid SACD – SACD
CD Digital Direct – Off
Pure Audio Clock – Off
Move
1 Audio2 Video Language
Gain Setting
Center
Gain –
0.0dB
Test Tone Off
–
Move
–/+
ENTER
This setting should be made when the Mulutichannel AUDIO OUT
jacks on the rear panel are connected to an AV amplifier or receiver.
General
The output level of each speaker in your system can be set and
confirmed. The factory setting is set to "Fix". However, when you
Fix
want to adjust the output level, select "Variable".
Variable
SETUP Exit
When "Variable" is selected
1
Move the cursor control joystick right or left to select a
speaker.
Front Left, Center, Front Right, Surround Left, Surround Right,
General
Subwoofer, Front Left, ...
L R
Speakers set to "Off" in the [Speaker Setting] setting cannot be
selected.
SW
LS RS
Move the cursor control joystick down.
Return
Select Exit
SETUP
2
Move the cursor control joystick right or left to set the
output level.
The value can be adjusted in the range of -6.0 dB to 6.0 dB in 0.5
dB increments. The output level of front L/R speakers are fixed and
therefore cannot be adjusted.
3
Repeat steps 1 and 2 for each speaker in your system.
Move the cursor control joystick down.
4
Move the cursor control joystick right or left to output the
test tone to confirm the output levels.
Off
On
Auto :Test tone is automatically output.
When "On" is selected
Move the cursor control joystick up to the speaker selection line,
then Move the cursor control joystick right or left to select the
speaker to output the test tone from. The test tone is output from
the selected speaker. To output the test tone from another speaker,
change the speaker selection.
When "Auto" is selected
Test tone is output in the following order.
Front Left, Center, Front Right, Surround Left, Surround Right, Front
Left, ...
5
Move the cursor control joystick up to the [Gain] setting,
then move the cursor control joystick right or left to adjust
the output level while listening to the test tone.
To stop the test tone
Move the cursor control joystick down to the [Test Tone] setting,
then move the cursor control joystick right or left to select "Off" in
the [Test Tone] setting.
Notes
• When "Variable" is selected, the output level of all speakers is uniformly
set to –6.0 dB. The output level of each speaker (center, surround, or
sub woofer) can then be adjusted in the range of –6.0 dB to 6.0 dB. "6.0
dB" is the maximum level of "Variable" and also the level set for "Fix".
Therefore, when "Variable" is selected, the output level will usually be
lower than when the setting is set to "Fix".
• The "Variable" setting has no effect on CD and Video CD playback.
• The test tone is not output when the setting is set to "2 Channel" in the
[Audio Out] setting (page 31), while the disc tray opens, or while a disc
is playing.
Adjusting Audio and Video Settings
:Test tone is not output. (Factory Setting)
:Test tone output is manually controlled.
Expert
33
En