Rear Panel - Pioneer DV-AX10 Operating Instructions Manual

Rear Panel

1
L
R
SURROUND
R
* The rear and under section of this appllance are copper plated to ensure quality sound. It may sometimes happen that marks
are left during the plating process, but this does not affect performance.
1
Multichannel AUDIO OUT jacks
Use to output 6 discrete audio channels of decoded
digital audio to a receiver or amplifier with discrete
audio inputs (page 18).
2
CONTROL jacks
Using a commercially available cord with a mini plug
(3.5 mm dia. with no resistance) to connect this
player's CONTROL IN jack to the CONTROL OUT
jack of another PIONEER component bearing the Î
mark, you can control the player as though it were a
component in a system (system control).
• If you connect for system control, you cannot
operate the player directly. Point the remote
control unit at the component (AV amplifier, etc.)
connected to the CONTROL OUT jack to operate.
• When controlling as a system, be sure to make a
connection to the amplifier using an audio or video
cord, even when using only digital components.
• For details, refer to the operation manuals of the
connected components.
3
VIDEO OUT jacks
Connect to the video input on a TV, monitor, AV
amplifier or receiver with video input capability (pages
14 and 16).
4
S-VIDEO OUT jacks
If your TV or monitor has an S-VIDEO input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-VIDEO jack.
(pages 16).
5
Component video output selection switch
Use to set the scanning system (interlace,
progressive, menu setting) being used by the TV,
monitor, or projector connected to the COMPONENT
VIDEO OUT jacks (pages 15 and 16).
2
3
1
IN OUT
SUB
CENTER
WOOFER
CONTROL
2
AUDIO OUT
VIDEO OUT
1 - GND
2 - HOT (+)
3 - COLD (-)
BALANCE
OFF ON
FRONT L
-
0
4 5 6
1
menu
select
Y
525i P P
R B
(480i)
525p
(480p)
2
COMPONENT VIDEO OUT
S-VIDEO OUT
6
COMPONENT VIDEO OUT jacks
If your projection monitor, projector or similar
component has component video inputs, you can
produce a higher quality picture on your projection
monitor or projector by connecting to the component
video outputs on this unit. When using these jacks,
be sure to set the component video output
selection switch to the correct position (pages 15
and 16).
7
DIGITAL OUT jacks (coaxial(COAX)/optical (OPT))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial or optical output jack to an AV amplifier or
receiver (pages 15 and 17).
8
PDIF jack
When using this player with the optional C-AX10
Digital Control Amplifier, connect to this jack using
the PDIF cable supplied with the C-AX10 (page 17).
9
Power cord
Use to connect the power cord to the wall outlet
(pages 14 and 15).
0
BALANCE ON/OFF switch
Use to set to ON if you are using the balanced audio
outputs (page 18)
-
AUDIO OUT FRONT jacks
Use to output two-channel audio (analog) to the audio
stereo inputs on a TV or stereo amplifier. If you are
connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 15 and
18).
Names and Functions
8
7
2COAX 1COAX
OPT
PCM
PDIF
DIGITAL OUT
9
11
En