Table of Contents
Advertisement
Operating Instructions
Setting
Camera Name
Vertical
Resolution
(for 640 × 480
mode)
Picture position
adjustment
3.
Click [Save] when finished.
•
New settings are saved.
•
When finished, "Success!" is displayed.
4.
Click [Go to Camera page].
•
The Camera page is displayed.
Note
Clicking [Save] saves the adjusted position. Clicking [Cancel] cancels your
settings without saving the position.
Picture position adjustment is reflected on the actual screen while
adjusting.
When not to click [Save], the video is displayed in the adjusted position
until turn the power off is turned off, however, turning the power back on
returns this product to the original position.
68
•
The camera name is displayed on the Single camera page.
•
Enter ASCII characters (see page 163) or characters in
each language (1—15 characters for a 1-byte character
and 1—7 characters for a 2-byte character). But [Space],
["], ['], [&], [<], and [>] are not available.
When selecting the video of 640 × 480 dot resolution on the
Single page, scanning lines may appear to record the fast
moving objects. When selecting 240, correct the scanning
lines.
The image area slips depending on the analog camera which
you connect, and the black bar may appear into the picture
edge. In this case, adjust picture position by clicking the icon on
up, down, left and right. Adjust the image to right in the
following example.
Description
Slipping
Adjust the image
to right to click here.
Advertisement
Table of Contents
