Troubleshooting - Olympus CAMEDIA C-700 Ultra Zoom Reference Manual

Troubleshooting

POSSIBLE CAUSES
1 The power is off.
2 The batteries are loaded
incorrectly.
3 The batteries are exhausted.
4 The batteries are temporarily
unable to function.
5 It is connected to a personal
computer.
1 The camera is in the Sleep
mode.
2 The camera is in the
playback mode.
1 The Monitor is in the Sleep
mode.
2 The camera is in the sleep
mode.
3 The camera is in the battery
save mode.
No picture is taken when the Shutter button is pressed.
1 The Mode dial is set to
2 The memory gauge is full.
3 The flash has not finished
charging.
4 The card access lamp blinks
after shooting in the
mode.
CORRECTIVE ACTION
The camera does not work
1 Press the POWER switch to turn
on the power.
2 Reload the batteries correctly.
3 Replace the batteries with new
ones.
4 Keep the batteries warm while
using the camera.
5 The camera will not operate while
it is connected to a personal
computer.
The viewfinder does not turn on.
1 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
2 Set the Mode dial to any position
except
The monitor does not turn on.
1 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
2 Operate the camera (press the
Shutter button, turn the Mode dial,
etc.)
3 Set BATTERY SAVE to OFF in
the Menu.
1 Set the Mode dial to any position
.
except
2 Wait until there is room in the
memory gauge.
3 Remove your finger from the
Shutter button and wait until the
flash charge mark stops blinking.
Take your shot again.
4 The recorded movie image data is
being written to the card. You can
start shooting again when the
card access lamp stops blinking.
.
.
.
REF. PAGE
P. 28
P. 23
P. 23
P. 164
P. 34
P. 47
P. 34
9
P. 34, 37
P. 129
P. 47
P. 15
P. 78
P. 41
183