Connect To Water Supply - Maytag Jetclean Plus MDB6709AW Installation Instructions Manual

8
Align front of dishwasher
with front of cabinet doors
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
9
Check for plumb and
adjust legs if needed
Check that leveling legs are firmly against the floor.
Close and latch the door, and place level against the
front panel. Check that dishwasher is centered from front to back
in the opening. If needed, adjust leveling leg until dishwasher is
plumb. Repeat for other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using the ³ " hex head
socket or adjustable wrench.
Preferred method Optional method
10
Check level side to side and
adjust legs if needed
Place level against top front opening of tub. Check that
dishwasher is level from side to side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.

Connect to Water Supply

1
Slide nut and ferrule
onto tubing
Copper tubing only: Slide nut then ferrule onto copper tubing
about 1" (2.5 cm).
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base, frame
or motor.
2
Connect water supply
using copper or flexible line
Copper tubing only: Put the tubing into the 90° elbow fitting as
far as it will go (the copper tubing bends and kinks easily). Slide
the nut and ferrule forward and start the nut onto the elbow
threads.
Flexible braided connection: Secure nut to elbow using
" open ended wrench or adjustable wrench.
NOTE: Do not use Teflon tape with compression fittings.
Nut
Ferrule
15