Install The Door Handle; Move Dishwasher Into Cabinet Opening - Maytag Jetclean Plus MDB6709AW Installation Instructions Manual

Dishwasher Height Adjustment Chart
Cabinet Wheel
opening height position
33 " (86.0 cm) Removed
34" (86.4 cm)
34 " (87 cm)
34 " (87.6 cm)
NOTE: If the minimum cabinet opening height is less than 34"
(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 33 "
(86 cm) high cabinet opening, but the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 34 " (87.6" cm).)
Adjust wheels and legs
2
Turn both leveler legs to the same height. Put wheels in the
required position determined from "Dishwasher Height
Adjustment Chart". (To change wheel position, use a flat-blade
screwdriver to pop out the wheel, then snap into the new
position.)
3
Built-up Floors — Add
shims as needed
2
"
( 5
c m
)
Built-up floors (Kitchen floor height is higher than cabinet
opening.) Example: Kitchen floor tile does not extend into
cabinet opening. Add shims as needed in the area shown to
bring the dishwasher up to 34" (86.4 cm) below the countertop.
NOTE: Shims must be securely attached to floor to prohibit
movement when the dishwasher is in use.
Number of turns
on front leg
All the way up
1 10
2 5
3 0

Install the Door Handle

Install door handle
Mounting
stud
Setscrew (inside of
door handle standoff)
IMPORTANT: Do not scratch the front panel during this
procedure.
Remove the door handle and hardware bag containing
the setscrews and Allen wrench from the cardboard box.
Start setscrews in handle. Place handle on mounting
studs with the setscrews facing down. Push the door
handle tightly against the door. Insert the short end of the
Allen wrench into the setscrews. Tighten the setscrews
3
turn past snug.
2
1
Move Dishwasher into Cabinet
1 Stand dishwasher upright
Using two or more people, stand dishwasher upright.
NOTE: Do not install kickplate until instructed.
(on some models)
Mounting stud
Allen wrench
Opening
Handle
13