Connect To Water Supply - Maytag MDB7759AWB3 Installation Instructions Manual

Check t hatleveling l egs arefirmlyagainst thefloor.
Close a ndlatch thedoor, a ndplace level a gainst the
frontpanel. Check t hatdishwasher iscentered f romfront
to back intheopening. If needed, adjust l eveling leguntil
dishwasher is plumb. R epeat forothersideofdishwasher.
Helpful "13p: Push uponfrontofdishwasher to raise
dishwasher offtheground to adjust f rontlegs. W ith
some installations, it maybeeasier t oadjust t hefrontleg
using the3/16" hexhead socket oradjustable wrench.
Place level a gainst topfrontopening oftub.Check t hat
dishwasher is level f romsideto side. I f dishwasher is not
level, a djust f rontlegsupor downuntildishwasher is
level.
Connect to Water Supply
Be sure rubber washer is properly seated in fitting. Slide
the 3/4"fitting up to the valve and hand-tighten to avoid
unintentional cross-threading. Hand-tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 1/4to 1/2 turn may be required to
seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can
result.
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat
previous step.
17