Connect To Water Supply - Maytag MDB7609AWB - 24" Tall Tub Dishwasher Installation Instructions Manual

Check t hatleveling l egsarefirmlyagainst thefloor.
Close andlatch thedoor, a ndplace level a gainst the
frontpanel. Check t hatdishwasher iscentered f romfront
toback intheopening. If needed, adjust l eveling l eguntil
dishwasher isplumb. R epeat forother s ideofdishwasher.
Helpful "13p: Push uponfrontofdishwasher to raise
dishwasher offtheground toadjust f rontlegs. W ith
someinstallations, it maybeeasier to adjust t hefrontleg
using the3/16" h exhead socket or adjustable wrench.
Place level a gainst topfrontopening oftub.Check t hat
dishwasher is level f romsidetoside. I f dishwasher is not
level, a djust f rontlegsupor downuntildishwasher is
level.
Connect to Water Supply
Copper tubing only: Slide nut then ferrule
onto copper tubing about 1" (2.5 cm).
NOTE: To avoid vibration during operation, route the
water supply line so that it does not touch the
dishwasher base, frame or motor.
Copper tubing only: Put the tubing into the 90 ° elbow
fitting as far as it will go (the copper tubing bends and
kinks easily). Slide the nut and ferrule forward and start
the nut onto the elbow threads.
Flexible braided connection: Secure nut to elbow using
5/8" open ended wrench or adjustable wrench.
NOTE: Do not use Teflon ® tape with compression fittings.
Hold the 90 ° elbow fitting still with one adjustable wrench
and tighten the nut with second adjustable wrench.
Helpful "l]p: Use a 5/8" open ended wrench for easier
access to tighten connection.
16