Complete Installation - Maytag Jetclean Plus MDB6709AW Installation Instructions Manual

6
Remove towel and replace
lower dishwasher rack
Remove towel from dishwasher. Reinstall the lower dish rack.
If needed, see website for animated representation
of this step. Visit www.whirlpool.com/anchoring under FAQ
tab.

Complete Installation

1 Put dishwasher on its back
Check that grounding clip is attached to the lower panel. Position the
lower panel behind the access panel. On some models there is
insulation on the access panel which must fall behind the insulation
on the lower panel.
2 Remove panels
Hold the two panels together and place them against dishwasher
leg. Using a Phillips or " screwdriver, reinstall the screws through
the holes in the access panel and the slots in the lower panel.
3
Apply Teflon ® tape
or pipe joint compound
Coarse threads
Check that the lower edge of the lower panel contacts the floor.
Adjust if necessary.
Connect 90° elbow fitting to
4
water inlet valve
Tighten access panel screws.
TEFLON is a registered trademark of E.I. Du Pont De
Nemours and Company.
Coarse threads
19