Jumpers; Chassis Intrusion Switch Connector: Jci1; Clear Cmos Jumper: Jbat1; Jumper - MSI 915G Neo3-FIR User Manual

Chassis Intrusion Switch Connector: JCI1

This connector is connected to a 2-pin chassis switch. If the chassis is opened,
the switch will be short. The system will record this status and show a warning
message on the screen. To clear the warning, you must enter the BIOS utility and
clear the record.
The motherboard provides the following jumpers for you to set the computer's
function. This section will explain how to change your motherboard's function through
the use of jumpers.

Clear CMOS Jumper: JBAT1

There is a CMOS RAM on board that has a power supply from external battery
to keep the system configuration data. With the CMOS RAM, the system can automati-
cally boot OS every time it is turned on. If you want to clear the system configuration,
use the JBAT1 (Clear CMOS) Jumper to clear data. Follow the instructions below to
clear the data:
MSI Reminds You...
You can clear CMOS by shorting 2-3 pin while the system is off.
Then return to 1-2 pin position. Avoid clearing the CMOS while the
system is on; it will damage the mainboard.

Jumpers

2
GND
1
CINTRU
JCI1
1
JBAT1
3
3
1
1
Keep Data
Clear Data
Hardware Setup
2-23