Hard Disk Connector: Ide1, Ide2, Ide3; Fwh/Lpc Debugging Pin Header: Jlpc1 - MSI 915G Neo3-FIR User Manual

Hard Disk Connector: IDE1, IDE2, IDE3

The mainboard has 32-bit Ultra DMA 66/100 IDE controllers integrated in the
chips Intel ICH6 and VIA 6410, which supports PIO & Bus Master operation modes
and it can connect up to two Ultra ATA drives.
IDE1 (blue)
Each one can connect a Master and a Slave drive. You must configure second hard
drive to Slave mode by setting the jumper accordingly.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second
drive to Slave mode by setting its jumper. Refer to the hard disk
documentation supplied by hard disk vendors for jumper setting
instructions.

FWH/LPC Debugging Pin Header: JLPC1

The pin header is for internal debugging only.
14
2 1
JLPC1
IDE2 (yellow)
IDE3 (yellow)
Note: When you use VIA VT6410 RAID IDE3 will
be Primary and IDE2 will be Secordary.
13
PIN
1
3
5
7
9
11
13
JLPC1 Pin Definition
SIGNAL PIN SIGNAL
LCLK 2 Key (no pin)
LRST# 4 VCC3
LAD0 6 FID0_LRST
LAD1 8 VCC5
LAD2 10 Key (no pin)
LAD3 12 GND
LFRAME# 14 GND
Hardware Setup
2-15