Safety Instructions - MSI 915G Neo3-FIR User Manual

Safety Instructions

1. Always read the safety instructions carefully.
2. Keep this User's Manual for future reference.
3. Keep this equipment away from humidity.
4. Lay this equipment on a reliable flat surface before setting it up.
5. The openings on the enclosure are for air convection hence protects the equip-
ment from overheating. Do not cover the openings.
6. Make sure the voltage of the power source and adjust properly 110/220V be-
fore connecting the equipment to the power inlet.
7. Place the power cord such a way that people can not step on it. Do not place
anything over the power cord.
8. Always Unplug the Power Cord before inserting any add-on card or module.
9. All cautions and warnings on the equipment should be noted.
10. Never pour any liquid into the opening that could damage or cause electrical
shock.
11. If any of the following situations arises, get the equipment checked by a service
personnel:
†
The power cord or plug is damaged.
†
Liquid has penetrated into the equipment.
†
The equipment has been exposed to moisture.
†
The equipment has not work well or you can not get it work according to
User's Manual.
†
The equipment has dropped and damaged.
†
The equipment has obvious sign of breakage.
12. Do not leave this equipment in an environment unconditioned, storage
temperature above 60
CAUT ION: Danger of explosion if battery is incorrec tly replac ed.
Replace only with the same or equivalent type recommended by the
manufacturer.
back such products at the end of their useful life. MSI will comply with the product
take back requirements at the end of life of MSI-branded products that are sold into
the EU. You can return these products to local collection points.
0
C (140
To protect the global environment and as an environmentalist, MSI
must remind you that...
Under the European Union ("EU") Directive on W aste Electrical and
Electronic Equipment, Directive 2002/96/EC, which takes effect on
August 13, 2005, products of "electrical and electronic equipment"
cannot be discarded as municipal waste anymore and manufac-
turers of covered electronic equipment will be obligated to take
0
F), it may damage the equipment.
iv